DediProg RACE100 Serial Flash Gang Programmer

Serial Flash High density proliferation has evidenced a Gang programmer weakness in the Market:
Many Universal Programmers are not adapted for SPI Flash Memories. To be universal, each different signal and power requirement must be multiplexed on each pin which may limit the performances due to delays and high capacitance, reducing the timing guard bands. Performances of most Universal Gang Programmer are limited and even risky when it comes to programming Serial Flash memories.

By Dedicating its Gang Programmers, DediProg is able to optimize and offer the best possible solution on the market.

The Race100 is a Serial Flash Gang Programmer designed for high speed and high volume Serial Flash programming. Optimized for the SPI Flash, the Race100 is on average:
 8 times faster than the Universal Programmers in the market + 5 times more sockets for parallelism (High densities) = 40 times Higher Throughput.
This results in a 20% to 40% cost reduction for programming services

If you have significant volume of Serial Flash to be programmed the Race100 is your solution.

To fulfill the different requirements of Low Density and High Density Serial Flash, the Race100 comes in three models:
1) Race100-S20 accepts up to 5 Cartridges with 4 sockets each (20 sockets as shown above)
2) Race100-S8 accepts up to 2 Cartridges with 4 sockets each (8 Sockets - not shown)
3) Race100-S4 accepts one Cartridge with 4 sockets (4 sockets - not shown)

Cartridges are available for: SO16W packages, SO8W packages, SO8N packages, MLP5*6 (WSON) packages and MLP6*8 (WSON) packages

The RACE100 Serial Flash Gang Programmer is your solution to high volume Serial Flash programming, there is nothing else on the market that even comes close.
Contact us if you require more information and for the current prices.

Back to Device Programmers

Back to On-Line Store