|
This compact adapter allows you to convert an Older IDE drive for use with a SATA connector. Take your new board with SATA connectors and use your standard IDE drives with this amazing device.
IDE Device --- > Serial ATA Device!
Space saving design fits right up against the back the the IDE device which is perfect for tight places.
ALL EIDE Type DVD / DVD-RAM / CD-ROM / CD-RW / HDD Become New Serial ATA (SATA) Devices!
Attach this Mini Dongle board to the back of all types of ATAPI, ATA/133, ATA/100, ATA/66, ATA/33, EIDE and IDE storage devices (such as Hard Disk, DVD, DVD-RAM, CD-ROM, CD-RW etc.) and make them become new Serial ATA Devices and meet the SATA standard.
General Features:
* One to One Serial ATA (SATA) to Parallel ATA interface adapter
* Compliant with Serial ATA 1.0 specification
* Supports data rate of 1.5Gb/s for Serial ATA mode transferring
* Supports Ultra ATA /100133 and backward compatibility
* Support 3.5” IDE hard drive and 5.25” CDROM
* Driverless (No driver required)
Specifications:
* Serial-ATA (SATA) Interface
* Serial-ATA 1.0 specification compliant
* External power connector
* IDE Interface
* Support 3.5-inch IDE hard drive and 5.25-inch optical drives
* Connect an IDE hard drive to a SATA controller
* Serial ATA 1.0 compliant
* Supports most ATA 100/133 hard drives
* Supports large capacity hard drives
* Simple Plug and Play Installation
* Compatible with most Serial ATA (SATA) controllers.
Dimensions:
L = 58.7mm
W = 25mm
H = 18.2mm (including connectors)
Note: Some versions have a HDD (Molex) connector and not a Floppy connector on the PCB.
A small piece of rubber or other insulator should be inserted between the PCB and the IDE device.
Need cables for this device? CLICK HERE.
Click Here to see the installation manual
|
